Identify the system
Confirm the model, stages and installation date before ordering.
Timely replacement helps preserve flow, treatment performance and the useful life of downstream components.
Request service→
Confirm the model, stages and installation date before ordering.
High use or challenging source water may shorten replacement intervals.
Keep the date and parts used for the next maintenance cycle.

Your recommended interval should reflect the installed configuration and household conditions. Contact support if the original schedule is unavailable. We can check what was installed and when, which is more reliable than a general figure from a manufacturer's range that may not describe your stages at all.
Media is consumed by the water that passes through it, so the same equipment in a four-person household and a two-person household reaches the same point at different times. What the water carries matters as much as the volume: a supply with more sediment loads a pre-filter faster, and a pre-filter that blinds early starts protecting the stages behind it less well. The interval is a function of your house, not of the box.
A staged whole-home system consumes its coarse pre-filter first, because that stage exists to protect what follows. Carbon media is replaced on its own interval. A reverse osmosis system has pre- and post-filters on a relatively frequent cycle and a membrane on a much longer one, and the pre-filters are what keep the membrane alive. A salt-based softener is different in kind: salt is topped up as it is used, and the resin is checked over time rather than replaced on a schedule.
The honest answer is that you often notice nothing until the complaint the system was installed to fix starts coming back. Exhausted media does not fail visibly: the taps still run and nothing leaks. A loaded sediment stage can show as reduced pressure, and a softener out of salt shows as soap lathering poorly again. None of these is a reliable schedule, which is the reason to work from the interval rather than from symptoms.
Do not open a pressurised housing, alter a bypass valve or work near electrical equipment unless you are qualified to do so. Whether a given change is a homeowner task depends on your configuration, so ask before assuming. If you are not certain which stage is which, that is a good reason to have us do it rather than to work it out at the time.
Contact support with your address and we can check what was installed and when, then tell you what is due and roughly when the next change falls. There is no need to guess from a manufacturer's general range.
The stage stops doing its job gradually rather than failing, so the complaint the system addresses returns without anything appearing to break. On a staged system a loaded pre-filter also stops protecting the stages behind it, which can shorten their life.
Yes. Service requests are handled against that record, which is why the first question is usually your address rather than a model number you may not have.
Send the system details and preferred service timing.