Monthly glance
Check the installation area for obvious leaks, damage or access problems.
Keep system details, service dates and filter information together so maintenance remains predictable and support is easy to arrange.
Arrange service→
Check the installation area for obvious leaks, damage or access problems.
Follow the replacement plan supplied for the installed configuration.
Store dates, parts, technician notes and any changes in water conditions.

Do not open pressurized housings, alter bypass valves or work near electrical equipment unless authorized and qualified to do so. Which tasks on your system are homeowner tasks depends on the configuration that was installed, so ask rather than assuming. Nothing in this guide is worth a risk to you or the property.
Treatment media is consumable by design. When it is exhausted, water passes through much as it would have without it, and nothing visibly fails to tell you so: the taps run, nothing leaks, and the complaint the system was installed to fix gradually returns. That is the reason to work from an interval rather than from symptoms, because by the time there is a symptom the system has already stopped delivering what it was bought for.
Three observations, none of which requires opening anything. Check the salt level if you have a salt-based softener, because a softener that has run out stops exchanging hardness. Notice whether taste or smell has changed at the kitchen tap. Notice whether soap and shampoo are lathering as they were. Any of these changing is worth noting with a date, because when it started is the single most useful thing you can tell us.
What was installed and when, what each stage is for, the replacement intervals you were given, and the date of every service visit or filter change. Keeping this somewhere you will find it turns a future diagnosis into a two-minute conversation. We hold the installation record as well, so a lost schedule is recoverable, but the dates of changes you have made yourself are only yours.
Media and filter replacement where the housing is not a homeowner task, resin checks on a softener, membrane replacement on a reverse osmosis system, regeneration settings, and anything involving a leak, a pressurised component or electrical equipment. Settings in particular are worth leaving alone: a regeneration cycle adjusted without reference to the configuration can leave you with a system that uses more salt and softens less.
Replacement intervals →What to check first →Request service →
Observation, and topping up salt on a salt-based softener. Whether any filter change on your system is a homeowner task depends on the housings that were installed, so ask before attempting one, and never open a housing you are unsure about.
From the intervals you were given at handover for the equipment installed. If you no longer have them, contact support with the installation address and we can check the record rather than estimating from a general range.
Better not to. Regeneration settings were set for the configuration and the household, and adjusting them without that context can result in more salt used and less hardness removed. If you think the setting is wrong, report it and we will check it.
Share the system details and last service date.